Press releases
December 14, 2022

We will be exhibiting at Micronora on 27-30 September 2022

We will be exhibiting at Micronora on 27-30 September 2022

We will be exhibiting at Micronora on 27-30 September 2022

From 27 to 30 September 2022, we will have a stand at the Micronora trade fair in Besançon, France, which is the largest micro technology exhibition in Europe. We would be delighted to welcome you to our stand to see and touch our actual μ-MIM parts. This is a joint stand with Incus GmbH, a manufacturer of metal 3D printers using the Lithography-based Metal Manufacturing (LMM) method. We look forward to seeing you there.

URL: https://micronora.com/en/

Date: 27-30 September 2022

Place: Parc des Expositions Micropolis / Boulevard Ouest, Besançon, France

Hall: C

Booth: 504

Contact: Ms. Izumi Nakamura (i.nakamura@micro-mim-japan.co.jp)

Conclusion

Cracking, slumping or blistering is commonly observed due to the binder swelling and/or residual stress difference between the surface and interior. It is possible to avoid these problems by selecting appropriate organic solvents and temperature control.

The catalytic deboning uses sublimation of binder, thus it is possible to decompose the binder in relatively short processing time with minimizing the deformation. However, with a strong acidic atmosphere, theapplicable metal material option is limited.

In the sintering process, the necking, which is bridging the metal powders by thermal diffusion, starts at the sintering temperature. Once the necking starts, the shrinking is observed and increases the density, thus before starting the necking reaction, all the organic components should be decomposed and gas between the powders should be removed. In the sintering process, the unwanted chemical reaction, such as oxidation or carbonization, leads to mechanical property loss, therefore a precise atmosphere control with low heating rate at the beginning of the process is required. Also, when it reaches the sintering temperature, some add it vegetal can be evaporated.

Share this post

Related posts

Check out our technology article in the "INNO" magazine from IVAM Microtechnology Network!
Press releases
November 20, 2023

Check out our technology article in the "INNO" magazine from IVAM Microtechnology Network!

You can check out our technology article in the "INNO" magazine from IVAM Microtechnology Network now! Please take a look to learn more about our technology.What is INNO?
Read more
Announcement: Exhibiting at MD&M West 2024
Press releases
October 27, 2023

Announcement: Exhibiting at MD&M West 2024

We will be exhibiting at MD&M West 2024 to be held at the Anaheim Convention Center, Anaheim, California, USA from February 6 to 8, 2024.
Read more