MIM tips for designers
MIM Design Tips #09

August 28, 2019
Manufacturing / Gate treatment Pt. 3
Unfortunately, it is impossible to avoid the rough surface at the gate.Normally, the gate roughness is convex, thus post treatment might be required.
Read more
MIM Design Tips #08

August 27, 2019
Manufacturing / Undercut and internal curve design
Applying our 3D-MIM technology, it is possible to mass produce complex hollow design or micro size configuration.
Read more
MIM Design Tips #07

August 26, 2019
Manufacturing / Gate treatment Pt. 2
Employing film or flash gate to eliminate weld line and improve the roundness tolerance.
Read more
MIM Design Tips #06

August 25, 2019
Manufacturing / Gate treatment Pt. 1
Apply higher level of gate will minimise the polishing amount.
Read more
All articles
Read our micro MIM technical Newsletter
Our technical newsletter is about our μ-MIM® technology including the latest development of Micro MIM Japan.

Read our MIM tips for designers
Our technical newsletter is about our μ-MIM® technology including the latest development of Micro MIM Japan.

See our latest news and press releases
Our technical newsletter is about our μ-MIM® technology including the latest development of Micro MIM Japan.
